Pot holder rotary cutter case

Just saw this in the new F and P mag...I vaguely remember a discussion about it sometime back, but thought I'd bring it up...a good idea if maybe someone hasn't heard about it. Take a square pot holder (you can use the "cheap dollar store kind", fold it over and stitch along the bottom and side, leaving the top with the hanging loop open. It now is a case for your rotary cutter and can hang on peg board, etc. There's a linen store closing out in my area...may go look for some larger flat pot holders...lol.

thanks for that idea.... I can use it...

Yes good idea for sure!!

It is a good idea..especially the little hanging loop!